Home
Back
HB to HRB Conversion Formula:
| From: | To: |
The HB to HRB conversion provides an empirical relationship between Brinell hardness (HB) and Rockwell B hardness (HRB) scales for steels with hardness values below 450 HB. This conversion is useful when comparing hardness measurements from different testing methods.
The calculator uses the empirical conversion formula:
Where:
Explanation: This empirical formula provides an approximate conversion between the two hardness scales for steels, with the limitation that it's most accurate for materials with Brinell hardness below 450 HB.
Details: Hardness conversion is essential in materials engineering when comparing test results from different hardness testing methods, selecting appropriate materials for specific applications, and ensuring quality control in manufacturing processes.
Tips: Enter the Brinell hardness (HB) value. The value must be positive and valid. Note that this conversion is empirical and most accurate for steels with hardness values below 450 HB.
Q1: What is the difference between HB and HRB hardness scales?
A: Brinell (HB) uses a 10mm ball indenter with heavy loads, while Rockwell B (HRB) uses a 1/16 inch ball indenter with lighter loads. They measure hardness differently but can be correlated for many steel materials.
Q2: How accurate is this conversion?
A: This is an empirical conversion and provides approximate values. Accuracy may vary depending on the specific steel composition and heat treatment.
Q3: Can this conversion be used for all materials?
A: No, this conversion is specifically for steels and is most accurate for materials with Brinell hardness below 450 HB.
Q4: When should I use actual hardness testing instead of conversion?
A: For critical applications or when precise hardness values are required, actual hardness testing using the appropriate scale is recommended rather than relying on conversions.
Q5: Are there limitations to this conversion?
A: Yes, the conversion becomes less accurate for very hard or very soft materials, and for non-steel materials. It should be used as a guideline rather than an exact conversion.